I'm new to this generation of PLCs, CompactLogix. I'm trying to figure out how I can backup the parameters for Powerflex 525 inverters.
So far I've found out that if I am online and try to open one of the inverters (ethernet) it says Path Splicing - Failed to splice the path. However if I go offline I can see the parameters.
I'm just wondering in the even that we need to replace an inverter, is there a way to "push" the parameter information to the newly installed inverter? I don't see any obvious buttons for it, and I haven't had much luck Googling. I'm likely not phrasing my question well enough.. Ideas? Thanks,
