Connecting Generic I/O module to Micrologix 1100

Hello All, 

Am a bit new to practical PLC applications. I was trying to configure a Phoenix Contact I/O module (1452916) on a MicroLogix 1100 PLC but it kept faulting out with the fault light RED. It would say "Major Error Halt S:1/13". The error description says I/O mismatch. The error code is 187h (see attachment).

The Phoenix module has a cable with 19 pin positions for the 8 input. I connected the pin 17 and 18 to 24 volts and  0 volts respectively. Then because I was using input 5 I connected the pink wire to PLC input (I/1) 24volts and the White/Yellow wire to the PLC common. 

On the I/O configuration on RSLogix 500, I used "Other" ( See attachment) but did not know the vendor details.

Could anyone help me with the steps on how to communicate with the module?

I have also attached the PLC program I was running.

Thanks