Hey everyone; Having a problem with RSLogix5000 and a Contrologix L62 Processor. Was adding a MAVE block to a routine and a fatal error occurred as it was being created. I've verified the program offline and everything looks good up to that last live edit, which was the only outstanding change when the fatal error occurred. The last edit is not in the saved file. Now when I try to go online, I get a fatal error every time. I can't find a version of the program that will go online. I can't even upload from the controller and make a new file just to look at it. Aside from the obvious of stopping the controller and uploading a fresh copy of the saved program, does anyone know if there anything I can do to get online and perhaps repair the problem? The processor is running and the plant is running fine. The edit was for some ongoing work that has not been implemented, so it hasn't affected operations. The plant has no scheduled downtime for a couple of weeks, so stopping the controller is not an option right now. I'm hoping for a solution that can be performed in run mode. I've also looked into whether this customer has a Rockwell Support agreement, which at this point is a real thorn, as the tech support will do nothing without it. I've attached the fatal error message the program generated when it went down, in case someone has seen this before. Thank for any help that can be offered. Happy programming, speakerman.
↧