I'll preface this with, I'm an Omron guy, that was what I was trained on. Took a new job with new challenges with AB. I've been able to navigate them so far but this has got me stumped. I'm currently programming a RFID badge reader to my trainer setup for the later introduction to the plant. My issue is with something that seems to simple to be a problem. A timer. My issue is the timer is started and counts up to the target number and then just resets to 0. Never triggers the DN bit. I'm sure this will be something stupid but I'm at a loss here. I'll attach the program via link. https://ibb.co/K7VXbC1
Thanks,
Don