There is a new Micro 850E that allows you to do implicit messaging to a Kinetix 5100 servo and a Powerflex 525. I can't seem to find any instructions on how to do it though. I am also at a disadvantage because I have never used implicit messaging or even Logix 5000 before. I am fluent in the Micrologix family and RSLogix500 (not that it is doing me much good anymore!)
The Kinetix 5100 manual describes how to set it up in Logix 5000 and I tried to follow along but nothing seems to match up.
Instead of using add-on instructions you use UDFB's. I have downloaded the UDFB's and set up the modules but now I am stuck. I don't know how to connect them all. There is no assembly instruction UDFB.
Has anyone done this before?
Thanks, Chuck