I'm looking for help to resolve an issue. I have a PowerFlex 755 at port 0, with a 20-HIM-X6 at port 1, a 20-COMM-E at port 5, Ethernet/IP at port 13, and DeviceLogix at port 14. I've set the IP address on port 5 to 0.0.0.0 and enabled BOOTP for port 5 since I don't intend to use it. The correct IP address has been configured using the port 13 parameters of the Ethernet/IP module. I can see the VFD in RSLinx and adjust its parameters using CCW. However, when adding the VFD to the I/O configuration in the RSLogix 5000 PLC program, I get a "Module Not Configured" error. I selected PowerFlex 755 EENET while adding the hardware. I would like to know if these steps are correct or if there's anything else I should check or adjust.
↧