I have a PanelView Plus 1000 Cat # 2711P-RDT10C of which I need to edit the project. However, the integrator did not do me the courtesy of including a "go to config" button anywhere in the project. I'm not sure what firmware version it's running but I did a little bit of research about how to get to the config screen and I know that the firmware is old enough that it doesn't have the little white box during boot up to force the HMI into the config mode.
I found an article that said I would have to dismantle the HMI and remove the internal Compact Flash card in order to make changes. Is there any other option?